![]() Some suggestions for QR code placement: on the iPad stand base, corner of the whiteboard, teacher's desk, front of the room, etc. Then you can increase the size of the image and print it out. You can save a screenshot of your AirServer QR code. If you use the " Snip & Sketch" built-in screenshot program on your computer. It will also temporarily add the word "Connect" to identify which AirServer to connect to (in case there are multiple available and listed in the school). ![]() This QR code will not work with the native scanner app on an iPad only the AirServer Connect App. If successful, the app will display a checkmark and then inform you to Screen Mirror to your computer. Once this is enabled, a QR code will appear in the bottom-right corner of the program, scan this with the AirServer Connect iPad app. In the Settings ( ≡) of AirServer, under Personalization, please enable " Network Discovery QR Code". These instructions can be found on the desktop of classroom computers for easy. This App requires one manual change to AirServer. Locate the Air Server icon in the system tray at the bottom of the screen. If your iPad doesn't have the App please submit a Helpdesk ticket and request the App be added to your iPad. The AirServer Connect App has been added to some Classroom iPads. This app has proven to be quite helpful with reconnecting to AirServer. To make connecting a Classroom iPad more consistent, it is suggested you use an App called " AirServer Connect". To quickly resolve this issue on a shared computer, restart the computer and launch AirServer again. It is good practice to close AirServer when you're not using the program and when another staff member is going to log in and use the computer. If AirServer is left running on another user account that is signed into a computer there may be some connection issues. This can cause issues if you have TOCs or other teachers logging into the same computer as it will keep reverting to the computer name with each different user. Note: Please do not rename your AirServer program. Select the destination that matches the name of IPad’s screen to bring up the Control Center (see detailed instructions below) Swipe down from the top-right corner of your Point iPad camera at QR Code, wait for green checkmark for verification Settings (≡) > Personalization > enable "Network Discovery QR Code" Firmware release notes can be found here.Open “Software Centre” program on Windows computer It is recommended to log into advanced settings and check for updates in the Updates section, as new firmware may be available. The on-screen display will no longer show the Quick Setup instructions. Once setup is completed, all settings can be accessed by selecting Advanced Settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |